Like your Z, this site is always underconstruction. :-)

Door shells with perimeter frame

Very light, full racing door. You can: 1) leave it open to clear the sidebars of your roll cage; 2) use the factory inner door panel (aka "card"), or; 3) use our fiberglass inner panel.

Datsun Z S20 fiberglass Door shells with perimeter frame 1Datsun Z S20 fiberglass Door shells with perimeter frame 2Datsun Z S20 fiberglass Door shells with perimeter frame 3Datsun Z S20 fiberglass Door shells with perimeter frame 4

This door uses the stock hinges/bolts, and can use stock latch. But there's no pocket in the door skin for the outer handle... which we can add-in for a small extra charge.

You can use the stock window frame and regulator, with either stock glass or Lexan windows, but some bracket fabrication will be required.

If you don't want to run windows, you can glue our door cap ($49 each) over the window slot on the top of the door. 

These doors were designed to reduce weight compared to the stock doors. They are available in two configurations: 1) with a full inner fiberglass panel having integral arm rests, and 2) with a perimeter frame designed to allow the door to be left hollow.

pdfZTrix-Fiberglass-Z-Door-Installation-Guidance.pdf

$495.00
* Each Side (referenced to left-hand drive models. LHD):




USA check
Made in the USA for reduced ordering time and less expensive shipping.
Ask a question
1000 characters left
Back to top