Like your Z, this site is always underconstruction. :-)

Door Skin

These door skins can be attached to the roll cage of your race car with Dzus quarter-turn fasteners, or they can be used to overskin a tubular door to make it match the factory fender/quarter panel lines.

Our door shells consist of these door skins bonded to an inner skeleton, or the door skins can be bonded to an inner panel with built-in armrest.

Each door skin weighs 5lbs

These doors were designed to reduce weight compared to the stock doors. They are available in two configurations: 1) with a full inner fiberglass panel having integral arm rests, and 2) with a perimeter frame designed to allow the door to be left hollow.

pdfZTrix-Fiberglass-Z-Door-Installation-Guidance.pdf

$190.00
* Each Side (referenced to left-hand drive models. LHD):




USA check
Made in the USA for reduced ordering time and less expensive shipping.
Back to top