Like your Z, this site is always underconstruction. :-)

The Velo Rossa Spyder/Velo Rossa Coupe is a complete rebody package for the Datsun "Z" Car series, 240Z, 260Z, 280Z from 1970 to 1978. Unbolt your front end components and install the clamshell bonnet OR a hood and nose clip (more like the original Italian version); glue on door over-skins; trim rear wheel arches (and cut roof for the Spyder); and glue on the rear clip. Choose from a wide-variety of readily-available aftermarket suspension and drivetrain performance upgrades.

VR Bonnet Hinge Ring

provide a secure hardpoint for the bonnet to pivot
$170.00
Read more: VR Bonnet Hinge Ring

VR Bonnet Hinge Pin

$8.00
Read more: VR Bonnet Hinge Pin

VR Door Skin

Velo Rossa door skins will work with either the other Velo Rossa components or the Alpha GTO parts.

$190.00
Read more: VR Door Skin

VR Windshield Header Cap

Covers the cutoff edge of the roof.
$145.00
Read more: VR Windshield Header Cap

Trunk Lid

$395.00
Read more: Trunk Lid

Alpha GTO front clip

Bolt-on front clip attaches via the stock fender mounting bolts and threaded bosses.

$2,350.00
Read more: Alpha GTO front clip

Alpha GTO inspection lids

These inspection lids are shaped to mate with the Alpha GTO front clip and hood.

$95.00
Read more: Alpha GTO inspection lids

Alpha GTO rear clip

Includes sail panels to cover the Datsun rear quarter windows.

$1,749.00
Read more: Alpha GTO rear clip

Alpha GTO Hood

Two-piece, pre-bonded hood has outer skin and inner reinforcing panel.

$595.00
Read more: Alpha GTO Hood

Bonnet Cooling Duct

$57.00
Read more: Bonnet Cooling Duct

VR Hard Top Shell

$595.00
Read more: VR Hard Top Shell

Le Mans Fuel Filler Pocket

Can be purchased separately for retrofitting, or bonded into rear clip at time of ordering.
$69.00
Read more: Le Mans Fuel Filler Pocket

Bonnet Triple Scoop

One of the most distinctive features of the Velo Rossa can be adapted into the early Alpha One GTO replicas to eliminate their smaller scoops which are not level from front-to-back, and therefore allow rainwater to pool in them. These scoops can also be adapted into a variety of other panels.

$150.00
Read more: Bonnet Triple Scoop

VR Driving Light Trim Rings (pair)

Price is for a pair. Cast, polished aluminum trim rings adapt modern rectangular driving lights or fog lights into the semi-oval openings on GTO replicas. Some perimeter sanding may be required for precise fit.

$125.00

VR Headlight Covers (pair)

Lexan headlight covers are formed to fit the shape of the headlight scoops on the Velo RossaPrice is for a pair. 

$195.00
Read more: VR Headlight Covers (pair)

VR Driving Lights

Includes bezel, reflector, glass lens, and bulb.

$195.00
Read more: VR Driving Lights

VR fog Lights

Just like our Driving Lights except with yellow reflector and wide-angle dispersion lens. Complete with trim ring, bulb, wiring pigtails.

$195.00
Read more: VR fog Lights
USA check
Made in the USA for reduced ordering time and less expensive shipping.
Back to top